We are pleased to be able to make various new functions available at the turn of the year.
Here is a list of the current extensions.
Multiple 230V feeds configurable
It is now possible to create a further 230V feed in the same wiring diagram.
This makes it possible, for example, to draw the input of a UPS or the emergency power branch of a PV system in the same plan.
In principle, it is now also possible to create a sub-distribution board in the main plan via an additional 230V feed. However, we recommend that you continue to use a separate plan in order to have a separate printout and numbering for each sub-distribution board.
Deactivation of the 230V supply possible
The drawing of the 230V feed can now be deactivated. This makes it possible to draw a pure 24V plan or a UV that only has KNX components.
Surge protection for extra-low voltage and bus systems
Overvoltage protection can now also be added under a power supply unit for 24V protection, as well as for bus systems.
Further optimizations
- We have significantly reduced the download size of the PDF exports. Previously, the company logos were integrated individually on each page in the PDF, which increased the download size. The logo graphic is now reused on all pages.
- With direct connectors, the channels of the heating actuators can now also be assigned. This helps when drawing pure heating circuit manifolds with several supply lines and switching in the heating circuit manifold.
- REG sockets are now also mentioned in the export of protection devices if they have been arranged under a protection device.
- On monitors with a higher resolution, the planning is now displayed much wider so that you can see more of the planning at once.
- There are small layout optimizations in the PDF export for the phys. address of actuators in the legend so that it does not protrude over the edge.
- Disconnectors are now also available in a 2-pole L/N version.
- Branches with three-digit numbers in very extensive plans are now drawn better.
